SAE規格 AS9103 Revision B, 2022: (R)Aerospace Series - Quality Management Systems - Variation Management of Key Characteristics

SAE規格 AS9103 Revision B, 2022

産業規格・仕様書  >  SAE  > 




SAE規格 AS9103 Revision B, 2022

32,120(税込)

数量

書名

SAE AS9103 Revision B, 2022:(R)Aerospace Series - Quality Management Systems -
Variation Management of Key Characteristics
SAE規格 AS9103 Revision B, 2022: 航空宇宙シリーズ - 品質マネジメントシステム -
キー特性のバリエーション管理
発行元 SAE International
発行年/月 2022年8月
装丁 ペーパー
ページ数 28 ページ
発送予定 海外倉庫よりお取り寄せ 1-2週間以内に発送します
※PDF版(シングルユーザー版)をご希望のお客様は別途お問合せ下さいませ。
※当ウェブ・ショップに掲載のない規格につきましては、別途お問合せ下さいませ。
※掲載の規格は、当ウェブ・ショップに掲載時点で確認できた最新版でございます。 最新の発行状況につきましては受注時に改めて確認をさせて頂きますので予めご了承下さい。

 

Description

This standard is primarily intended to apply to new parts and products intended to be produced in an on-going production phase, but can also be applied to parts currently in production (e.g., manufacturing, maintenance). The standard is applicable to all production processes that influence the variation of KCs, as well as maintenance and service processes in which KCs are identified. It applies to organizations for assemblies and all levels of parts within an assembly, down to the basic materials including castings and forgings, and to organizations that are responsible for producing the design characteristics of the product.

The variation control process begins with product definition, typically stated in the design documentation (e.g., digital model, engineering drawing, specification) which identifies KCs, and leads to a variation management process for those KCs. This process may also be used for producer-identified KCs (e.g., process KCs, additional/substitute product KCs).

Producers and their subcontractors are responsible for flow down of the standard requirements to those external providers, who produce design characteristics and provide production and service provisions, to ensure that KCs conform to the customer’s requirements.

Purpose
This standard is designed to drive the improvement of manufacturing and maintenance processes through adequate planning and effective management of KC variation. This focus is intended to improve uniformity (less variation or minimum variation of product KCs) and acceptance probability of the end-product.

NOTE: Control of a product or process KC per this standard does not constitute, nor imply, acceptance of the resulting product. If variation management, under this standard, is to be part of an acceptance decision, the requirements need to be specified in the applicable product acceptance plan or contract.

Convention
- The following conventions are used in this standard:
- “shall” indicates a requirement;
- “should” indicates a recommendation;
- “may” indicates a permission; and
- “can” indicates a possibility or a capability.